Products

Electricide Chlorine Dioxide Systems

Ozone Bottled Water Disinfection Systems

Fiberstrut Channel and Fasteners

ProMinent Chemical Dosing Equipment

Fristam Stainless Steel Hygienic Pumps

Atlantium HOD UV Disinfection

Glasco UV

LSM Pumps Hose Pumps

Likuid Nanotek Ceramic Membranes

IPM Systems Powder Feed Systems

Chemical Dosing Systems

Ozone Systems

Chlorine Dosing Systems

Sodium Hypochlorite Dosing Systems

Gas Chlorine Dosing Systems

Chlorine Dioxide Dosing Systems

Electrochemical Generation Systems

Acid Chlorite Generation Systems

UV Disinfection Systems

Chemical Dosing Systems

Building Mount Dosing Systems

Skid Mount Dosing Systems

Fluoride Dosing Systems

Services

Chemical Dosing Systems ProMinent Ozone Chlorine Dioxide UV CircleClear Backwash Recovery Sodium Hypochlorite Aickinstrut Fiberstrut

us flag 

United States Office

aust flag 

Australia


United States

P: 702-938-6418  F: 702-938-4118  salesus@dioxide.com
Suite B-562 / 2654 W Horizon Ridge Pkwy
Henderson NV 89052-2803

Sydney (NSW)
P: +612 9999 4594  F: +612 9999 4534  sales@dioxide.com
Unit 9, 5-7 Prosperity Pde, Warriewood NSW 2102 Australia
Perth (WA)

P: +618 9337 5415  F: +612 9999 4534  saleswa@dioxide.com
Melbourne (Vic)

P: +613 9005 1681  F: +612 9999 4534  salesvic@dioxide.com

Home

Products

Chemical Dosing Systems

Applications

News

Services

Contact
Dioxide Pacific


Gas Chlorination Systems

We provide ProMinent Hydro gas chlorination systems for all applications requiring water disinfection using gas. A typical example is shown below.
 

Disinfection of Secondary Treated Effluent
Chlorine gas is stored in two banks of 4 x 920 kg drums in a dedicated storage room. Each bank of four drums is connected through superior valves and flexibles to horizontal headers. These headers are connected to 40 kg/hr vacuum regulators via a short flexible connection. The two Hydro vacuum regulators then connect to a vacuum operated auto changeover valve which provides left/right bank indication and directs chlorine gas through a 25mm UPVC pipeline to the ejector which is located in the dosing room.

This system was designed in 3D before installation, to ensure that the system would fit correctly into the room and so that the plant was shut down for the minimum possible time.

Gas chlorination system
gas chlorine dosing system


The old dosing system was replaced with a new plant which would enabled splitting of the chlorinated water from after the ejector to two dosing points. By-pass flow is directed to the ejector where chlorine is dissolved and then split off at manually adjustable rate using diaphragm valves and rotameters. The complete dosing plant is backboard mounted on the wall. Pipework is fabricated from schedule 80 grey UPVC.
 


At the final effluent point after the 30 minute detention tank, total chlorine residual is monitored using a ProMinent CTE probe and DMT monitor. The sample to the probe is filtered through a small multimedia filter to ensure the probe does not foul quickly. The measured value from the analyser is transmitted to the chlorine gas dosing control panel using an Elpro wireless radio gateway. At the main touchscreen control panel, flow pacing with residual trim is accomplished by automatic adjustment of the chlorine servo valve. Chlorine residual, flow and other parameters are logged using the touchscreen compact flash card and data is transmitted to the laboratory SCADA system using the wireless radio gateway. Alarms are sent to operators via SMS.
 

chlorine dosing control system


For more information on gas chlorine dosing systems or to obtain a quotation, please complete the feedback form on our Contact page.

[Home] [Products] [Systems] [Contact  Dioxide Pacific]